电力排管模具 高铁电缆管模具浇筑方便 尺寸标准

电力排管模具模板电力排管模具，梁为横向构件，其电力排管模板工程主要承受竖向荷载，如模板及支撑自重，钢筋、新浇筑混凝土的自重，以及浇筑电力排管混凝土时的施工荷载等。因此要求模板的支撑数量足够，搭设稳固。梁模板由底模及侧模组成，底模承受竖向荷载，刚度较大，下设支撑；侧模承受混凝土侧向压力。

The power pipe laying mold formworks are the power pipe laying mold. The beam is a transverse member. The power pipe laying mold works mainly bear vertical loads, such as the self weight of the formwork and support, the self weight of the reinforcement and the newly poured concrete, as well as the construction load when pouring the power pipe laying concrete. Therefore, the support of formwork shall be sufficient and the erection shall be stable. The beam formwork is composed of bottom formwork and side formwork. The bottom formwork bears vertical load, has large rigidity, and is supported under it; The side formwork bears the lateral pressure of concrete.

埋线管模具是一种生产在各种电缆建设地区所保护电缆线路的混凝土制品的模具，为了能够保证电缆在穿过管道时容易通过，摩擦系数能够比较低，我们通常会建议各个预制厂先提前订购一批直径、长度规格同模具相同的塑料管，这样在进行生产的时候，就能够比较顺利的让电缆穿过，不会造成电缆线表面摩擦受损。

The buried pipe mold is a kind of mold for the production of concrete products for the cable lines protected in various cable construction areas. In order to ensure that the cable can pass through easily when passing through the pipe and the friction coefficient can be relatively low, we usually recommend that each prefabrication plant order a batch of plastic pipes with the same diameter and length specification as the mold in advance, so that the cable can pass through smoothly during production, It will not cause friction damage to the cable surface.